Command start
Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=66198
Printed Date: May 12, 2025 at 5:04 PM
Topic: Command start
Posted By: hclee
Subject: Command start
Date Posted: November 13, 2005 at 4:35 PM
I have a Commannd Start with a remote model # cs-555 bought the car used. Could anyone give me the sequence to start a car with manual transmission.
-------------
hclee
Replies:
Posted By: tragik
Date Posted: November 13, 2005 at 6:23 PM
with the engine running, pull the e-brake and hit button 1 on the transmitter. The parkinglights should come on.
Then yuo take the key out of the ignition, and get out. The car will stay running until you close the door. Now you can start the car.
-------------
Northstart.....or start it your damn self.
Posted By: griz660
Date Posted: November 16, 2005 at 3:46 PM
hello i have the same remote system but with a automatic car.....would you know the sequence i would need to get my new remote to work?? thanks
Posted By: tragik
Date Posted: November 17, 2005 at 2:42 AM
Its been a little while since I have done a command start, but I think the remote coding procedure is as follows
1) push the hoodpin down and quickly release it. The p.lights will come on. With the lights still on,
2) push the hoodpin down again, and release it. THe lights should stay on.)
3) press button 1 until the lights go out, then close the hood.
That should work, unless they have a new remote coding procedure since I installed them
-------------
Northstart.....or start it your damn self.
|