I,ve had to replace 3 heater resistors over the last 2 years, It is the resistor that controls the 3 lower blower speeds I,ve also replaced the blower motor. Dodge has no explanation for this. I would very much apreciate any advice. Thanks, Daniel
well they are the most common blower resistor to go. i must have replaced countless in the years i've been working on auto's. exspeacily the newer dodge. it does semm werd that you've gone through 3 of them. but i right it off at bad design that hasn't gotton the attention it needs. my 00 caravan blower motor resistors spent too. only work on high.
i've had faulty switches also from them i will post the schematics if there availble and you might want to check the compoents in the system. hopefully that helped .
-------------
JUST ONE MORE AMP!!!
hu,alpine cva 1005/dva 5205
sound processor,symmetry(first one).
sub amp,power 1000 the terminator.(1992).
subs,spl comp dual 1 ohms.
punch 150hd on a 10" ev.
alotofhighs
schematic is too large i will need to send it via email. if you want it pm good luck
-------------
JUST ONE MORE AMP!!!
hu,alpine cva 1005/dva 5205
sound processor,symmetry(first one).
sub amp,power 1000 the terminator.(1992).
subs,spl comp dual 1 ohms.
punch 150hd on a 10" ev.
alotofhighs