Print Page | Close Window

i pod to kenwood krc-4028?

Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=71501
Printed Date: May 01, 2024 at 2:15 AM


Topic: i pod to kenwood krc-4028?

Posted By: 96bigdogg
Subject: i pod to kenwood krc-4028?
Date Posted: January 25, 2006 at 6:41 PM

whats the easiest way to hook up an i pod to my kenwood krc-4028:errr:

-------------
hard hittin big dogg



Replies:

Posted By: KarTuneMan
Date Posted: January 25, 2006 at 8:48 PM

If its a changer controller use Peripheral part # PXDPA   129.95, with harness PXHKN1  19.95

                                                                      



-------------



Posted By: lspker
Date Posted: January 25, 2006 at 11:15 PM
You could but the IP500 ipod inteface from Kenwood, plug it into the change input, plug in the Ipod, put in the glove compartment and control it from the deck.  Or, by the aux in adaprter plug in the Ipod, turn on aux and control through the Ipod.



Posted By: nstaller36695
Date Posted: January 26, 2006 at 8:37 PM
if it does have the cd changer port use the kenwood ipod interface for sure u can actually run the wire to the glove box and control the ipod from the deck its the best way to go it cost about $ 100 but trust me not having an ipod hanging from the dash is nice.

-------------
the best part of a job is seeing the bumper get smaller over the horizon


Print Page | Close Window