I have a 95 mercury villager and i am planning to put the jbl crown 6000 amp in it. I have 2 jbl W15GTI's and plan to run them off the amp. Problem is, wiring kit, and how to run these 2 subs. The manual calls for 0 guage power and ground wires, with a min of 500 amp fuse. I've been looking and cant find a wiring kit that will handle that amount of current or power. Also with these two subs, they are 6ohms per coil, they are DVC. So thats 24ohms series? and 1.5 in parallel. I guess my question is where can i find a wiring kit for this amp, called jbl and thier no help, and how should i run these speakers for spl comps?
-------------
Nate Dizzie
First off, wrong forum, this should have been in the car audio section. But for your questions, any 0 gauge kit is gonna work if thats what it calls for, just because the fuse that comes with it isnt big enough doesnt mean that the wire cant handle the current draw. Replace the fuse and or fuse holder and your good to go. Check with Street wires for a proper fuse and fuse holder, they are gonna have what you need. As for wiring the subs, just go to 1.5 ohms and you'll be fine it its for SPL comps.
-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
Hey sorry, I didnt know it was the wrong forum, and thanks for the advice. Ill check out Street wires and some other places. I just thought that what was on thier site is what they had.
-------------
Nate Dizzie