change oil light on 2000 gmc sierra
Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=79177
Printed Date: April 29, 2024 at 12:02 AM
Topic: change oil light on 2000 gmc sierra
Posted By: djfearny2
Subject: change oil light on 2000 gmc sierra
Date Posted: June 15, 2006 at 9:51 PM
I use a 2000 sierra 1500 pickup truck for work and have changed the oil plenty of times, however on the dash when i start up it says change engine oil on the information section. is there a trick to reset that light thanks email me at nyinstaller@netscape.net if you have an answer
-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.
Replies:
Posted By: mj239air
Date Posted: June 15, 2006 at 11:04 PM
If it is the same as my suburban, turn the key to on, hit the gas pedal 3 times to the floor, turn the key off and then back on and it should reset.
Posted By: djfearny2
Date Posted: June 16, 2006 at 9:13 AM
that is right however what it is actually is
turn key to on possition
press and release gas pedel 3 times.
leave key on the change engine oil light flashes 5 times than goes away and its reset.
thanks anyway most of the post was true.
-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.
Posted By: doibuy
Date Posted: June 16, 2006 at 10:12 PM
Just wanted to add that the driver's door must be open in order for that to work. Also this should be found in the owner's manual
|