Print Page | Close Window

Predator 3501 in a 95 Contour

Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=8087
Printed Date: June 30, 2025 at 11:41 AM


Topic: Predator 3501 in a 95 Contour

Posted By: zimmb1
Subject: Predator 3501 in a 95 Contour
Date Posted: January 13, 2003 at 5:38 PM

 
I recently purchased a Predator 3501 car starter and am trying to install in a 95 Ford Contour. I have checked the wiring and it is all correct but the remote starter will not accept RPM programming.
This Contour has a distributorless ignition. Do you know where I can get more information to find out if this car starter will work in this car?
 



Replies:

Posted By: jcaimhigher
Date Posted: January 14, 2003 at 10:10 PM

The tach wire is behind the instrument cluster.  Remove the screws holding in the black trim with the vents in it.  The remove the screws holding the cluster in.  There are two wiring harnesses on the back of the cluster.  Even if the cluster doesn't have a tach on it the tach wire is still in the wiring harness.  It's a white wire with black stripe.  Splice in and you're good.  If you have more questions you can take a look at our site.  https://www.contour.org

HTH
John--2002 Mazda Tribute LX 4wd 3.0Duratec
         --1998 Mercury Mystique GS Spree 2.0Zetec ATX 



-------------
John
jcaimhigher@ixpres.com
Bond of the Blue Beret


Print Page | Close Window