Print Page | Close Window

command start CS2400

Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=9249
Printed Date: May 29, 2024 at 6:33 AM


Topic: command start CS2400

Posted By: stanley_cups
Subject: command start CS2400
Date Posted: February 08, 2003 at 9:32 PM

I am trying to install the Command Start CS2400 on my 1990 Nissan Maxima.  I can not find a wiring diagram for this model of Command Start.  Also, I am not sure how to deal with the factory alarm.

Thanks




Replies:

Posted By: Velocity Motors
Date Posted: February 09, 2003 at 8:02 AM

Command Start CS2400/2500 Installation Diagram

Click the above link for the wiring diagram.



-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA



Posted By: stanley_cups
Date Posted: February 09, 2003 at 8:47 AM

Thanks for the help!

How would you suggest I deal with the factory alarm?




Posted By: Velocity Motors
Date Posted: February 09, 2003 at 9:10 AM

|FCTRY ALRM DISARM|lt.grn/blk/ sil dots|-  |anti-theft module

There is a wire that is a (-) prior to start taht you can use from the CS2400.Attach it to this wire.



-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA



Posted By: stanley_cups
Date Posted: February 09, 2003 at 8:18 PM
New problem...I have the unit installed and when I press the start button, the car attempts to start by cuts of before turning over.  Any idea what I could be doing wrong?  I doubled checked all my wiring. 



Posted By: Velocity Motors
Date Posted: February 09, 2003 at 9:35 PM
Make sure that both starter's wires are connected ( Second Starter Relay Diagram ) and also, make sure that the tach signal is properly learned to the unit. Default setting for the unit is a 6 cylinder.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA



Posted By: stanley_cups
Date Posted: February 09, 2003 at 10:24 PM
I did make sure both starter wires are connected and have used a relay as per the relay diagram.  How do I make the tach signal learn to the unit.  Maybe you are onto something as this starter was in my friends intrepid.  I have installed it to my Maxima.  Both are 6 cylinders however.


Print Page | Close Window