Print Page | Close Window

2008 tacoma, rostra cruise

Printed From: the12volt.com
Forum Name: Cruise Controls
Forum Discription: Cruise Control Settings, Tach Signal, VSS PPM(Vehicle Speed Signal Pulses Per Mile), Vacuum, Brake, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=102052
Printed Date: June 21, 2025 at 3:15 PM


Topic: 2008 tacoma, rostra cruise

Posted By: rdcowan
Subject: 2008 tacoma, rostra cruise
Date Posted: February 10, 2008 at 9:56 AM

I bought a Rostra cruise control kit for my 2008 Tacoma with TR-FE (4 cyl.) engine.  The driver's side junction box does not look like figure 11 in the installation instructions. (link below)
 
Does anyone have a good diagram of the junction box?   -Or- can someone tell me which wire I should tap into?
 
By the way, I ran a wire from the battery in the driver's side window, took a drive, and the cruise works fine, I just need the correct power source!  (switched power)
 
Thank you!
 
Robert
 



Replies:

Posted By: Velocity Motors
Date Posted: February 10, 2008 at 12:03 PM
Go to your the lower right side of the fuse panel for your ignition wire. BLACK/ RED in the wire loom running across the lower portion of the fuse panel.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA



Posted By: jmroussel
Date Posted: February 16, 2008 at 8:37 AM

Velocity Motors wrote:
Go to your the lower right side of the fuse panel for your ignition wire. BLACK/ RED in the wire loom running across the lower portion of the fuse panel.

You're right Jeff, I ran in that situation before, the first one I did would not work right. There is a mistake in Rostra's instructions. I used the ign wire from ign switch and it works. I did many Tacomas since and no problems.



-------------
j-marc


Print Page | Close Window