2007 jeep liberty cruise

Printed From: the12volt.com
Forum Name: Cruise Controls
Forum Discription: Cruise Control Settings, Tach Signal, VSS PPM(Vehicle Speed Signal Pulses Per Mile), Vacuum, Brake, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=107535
Printed Date: May 01, 2025 at 6:57 PM

Topic: 2007 jeep liberty cruise

Posted By: smcshark
Subject: 2007 jeep liberty cruise
Date Posted: September 18, 2008 at 2:14 PM

Does anyone have any idea aside from a peddle pull on how to install a acruise on 2007 Jeep liberty with Drive by wire / electronic gas peddle ? The local Dodge dealer is driving me nuts.....

-------------
Automotive Electronic Specialist

Replies:

Posted By: sparkie
Date Posted: September 18, 2008 at 6:08 PM

I've only been able to do these vehicles with a pedal pull. They aren't too difficult, but you may have to install a magnetic speed pulse generator on the front drive shaft. If it is a manual transmission, installing a clutch switch is a real pain. Very little room to work in. Just make sure if you decide to do it add enough to the price to make it worth while.

-------------
sparky

Posted By: closmendez
Date Posted: October 26, 2008 at 1:00 PM

Just add a Factory switch from the Dealers part dept., You will have to add the pins to the clock spring. To gain access to the clock spring remove the air bag. Just adding a switch works. I work for a 5 star chrylse/mopar/jeep dealer. I install all the aftermarket accessories.

Print Page | Close Window