Can not set above 60 mph

Printed From: the12volt.com
Forum Name: Cruise Controls
Forum Discription: Cruise Control Settings, Tach Signal, VSS PPM(Vehicle Speed Signal Pulses Per Mile), Vacuum, Brake, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=12798
Printed Date: May 14, 2025 at 8:47 AM

Topic: Can not set above 60 mph

Posted By: MSU1878
Subject: Can not set above 60 mph
Date Posted: April 27, 2003 at 10:34 AM

I just installed an Audiovox CCS-100 in a 2002 Nissan Frontier 4 cylinder (I used the magnetic pickup too). It works great below 60 mph but will not engage above. Any ideas or suggestions?

Replies:

Posted By: the12volt
Date Posted: April 27, 2003 at 11:01 AM

Sounds like the servo doesn't have a strong enough vacuum source. Check your vacuum source and if necessary add a vacuum canister.

-------------
posted_image

the12volt • Support the12volt.com

Posted By: MSU1878
Date Posted: April 27, 2003 at 7:43 PM

I reset the unit to 4000 ppm and it now works great. It works great, even at 85 mph, I didn't try any higher speed.

Print Page | Close Window