OEM Switches with Rostra Cruise Control?
Printed From: the12volt.comForum Name: Cruise Controls
Forum Discription: Cruise Control Settings, Tach Signal, VSS PPM(Vehicle Speed Signal Pulses Per Mile), Vacuum, Brake, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135579
Printed Date: April 20, 2024 at 10:13 AM
Topic: OEM Switches with Rostra Cruise Control?
Posted By: bradleyb
Subject: OEM Switches with Rostra Cruise Control?
Date Posted: December 20, 2013 at 5:35 AM
I've installed cruise control in my '01 Honda Insight. It works great with the rostra RF switch, but I have swapped to an RSX steering wheel and I want to instead use the built-in switches on the new wheel.
I got it working basically by sending the switch 12V on the common input, and hooking the two outputs to the Rostra's yellow and green wires for "Set/decel" and "Resume/accel"
The only thing that doesn't work is the "Cancel" button. The switch has no output wire for "Cancel" - instead it uses diodes to activate both outputs at the same time:
Can anybody help me figure out how get the Rostra to understand this signal and disengage?
I got it working basically by sending the switch 12V on the common input, and hooking the two outputs to the Rostra's yellow and green wires for "Set/decel" and "Resume/accel"
The only thing that doesn't work is the "Cancel" button. The switch has no output wire for "Cancel" - instead it uses diodes to activate both outputs at the same time:
Can anybody help me figure out how get the Rostra to understand this signal and disengage?