Cruise Stopped working on 2000 Ranger
Printed From: the12volt.com
Forum Name: Cruise Controls
Forum Discription: Cruise Control Settings, Tach Signal, VSS PPM(Vehicle Speed Signal Pulses Per Mile), Vacuum, Brake, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=17042
Printed Date: May 29, 2024 at 2:23 AM
Topic: Cruise Stopped working on 2000 Ranger
Posted By: bianchina3
Subject: Cruise Stopped working on 2000 Ranger
Date Posted: August 02, 2003 at 7:22 AM
I have a 2000 Ford Ranger that the cruise has stopped working. A remote start was added to the vehicle and everything was fine until suddenly the remote stopped working. I believe the problem is electrical. I don't know where to start trouble shooting.
Replies:
Posted By: Powerslave0
Date Posted: August 13, 2003 at 11:52 PM
When you installed the REMOTE starter, you have to use the Tac/VSS signal so the unit knows the engine is running, and releaces the starter. IF that is the case, you are loosing the signal to the ECM, so cruise won't work. However, you should be getting a check engine light too. . . Also, he cool side effect of that is, your SPEED/REV limiter may also be removed. . . It is electrical in this case, you need to get the signal back to the ECM.
|