Wiring Hookup on Aftermarket Cruise Control Unit
Printed From: the12volt.com
Forum Name: Cruise Controls
Forum Discription: Cruise Control Settings, Tach Signal, VSS PPM(Vehicle Speed Signal Pulses Per Mile), Vacuum, Brake, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=19116
Printed Date: May 14, 2025 at 2:07 AM
Topic: Wiring Hookup on Aftermarket Cruise Control Unit
Posted By: Dave Mahle
Subject: Wiring Hookup on Aftermarket Cruise Control Unit
Date Posted: September 21, 2003 at 8:13 AM
I am rewiring ann old street rod that has an aftermarket cruise control in it. All of the hookup wires were markeed except one. There is a wire to the coil, ground, power, and the cold side of the brake light circut. Can anybody give me a clue as to where the last wire goes? Its red if that helps. There is no separate speed sensor that I can see so I assume that the coil hookup provides that function. Thanks in advance for your help.
-------------
Dave Mahle
Replies:
Posted By: NowYaKnow
Date Posted: September 22, 2003 at 6:38 PM
Usually here's the common hookup from the cruises I am familiar with:
Black - Ground
Brown - Ignition/Accessory Power
Blue or Gray - Tachometer Wire
Gray or Blue - Speed Sense Wire
Purple - Cold Side Of Brake
Red - Hot Side Of Brake
Good luck..If thats no good maybe you could tell us what type of cruise it is and somebody might know more.
|