E-150 CC

Printed From: the12volt.com
Forum Name: Cruise Controls
Forum Discription: Cruise Control Settings, Tach Signal, VSS PPM(Vehicle Speed Signal Pulses Per Mile), Vacuum, Brake, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=20530
Printed Date: May 14, 2025 at 2:47 AM

Topic: E-150 CC

Posted By: Robert Thomas
Subject: E-150 CC
Date Posted: October 24, 2003 at 9:14 PM

I think that I have found a good spot to mount the control module, but now another question. I pulled the big connector from the drivers side firewall. I can't find pin 58, I found the tach wire, but I am not sure about the VSS wire. I thought I had it (gray/black) but there is another wire that looks gray/black with maybe a blueish tint, if I knew which way the plug was numbered then I could confirm the right wire.

Thanks,

Bob T

Replies:

Posted By: Geeque
Date Posted: December 17, 2003 at 1:06 PM

Test with a volt meter, probe wire with a dmm and move throttle if a/c increases than you got it. YR and make?

-------------
Gary Kline
MECP Master Technician

Print Page | Close Window