Run away Ford
Printed From: the12volt.com
Forum Name: Cruise Controls
Forum Discription: Cruise Control Settings, Tach Signal, VSS PPM(Vehicle Speed Signal Pulses Per Mile), Vacuum, Brake, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=50496
Printed Date: May 06, 2024 at 7:44 PM
Topic: Run away Ford
Posted By: Go4DKil
Subject: Run away Ford
Date Posted: February 20, 2005 at 3:05 PM
I would like to know more about how to install a resistor and capacitor to prevent my ford truck from accelerating on its own while the cruise is set. I saw the following under the VSS section of the 12volt.com page.
Some vehicles may require additional parts. Ford vehicles with a Differential Speed Sensor, for example, may require an additional harness. This is nothing more than a resistor and a small capacitor. But if you don't use it, the cruise control will continue to accelerate. Be sure to consult your application guide before any cruise control installation. This will save you time and aggravation.
Thanks,
Jon K
-------------
Replies:
Posted By: airandsound
Date Posted: April 01, 2005 at 12:09 PM
that problem doesn't happen with the SCS/Frigette cruise.
|