2005 E-350, Drive by Wire, Cruise Control
Printed From: the12volt.com
Forum Name: Cruise Controls
Forum Discription: Cruise Control Settings, Tach Signal, VSS PPM(Vehicle Speed Signal Pulses Per Mile), Vacuum, Brake, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=54624
Printed Date: April 30, 2024 at 12:32 AM
Topic: 2005 E-350, Drive by Wire, Cruise Control
Posted By: mexi
Subject: 2005 E-350, Drive by Wire, Cruise Control
Date Posted: April 25, 2005 at 7:31 PM
Is there any thing you can do to add a cruise control to a vehicle with no throtle cable. Vehicle is a 2005 E-350 Diesel Van.
-------------
mexicang
Replies:
Posted By: Mad Scientists
Date Posted: April 25, 2005 at 7:55 PM
See how the factory does it.. you might have to go with a factory system. Jim
Posted By: NowYaKnow
Date Posted: April 25, 2005 at 8:51 PM
Almost everything is built into that vehicle already all you need to do is swap the wheel for one with the cruise buttons, change the clockspring, and have the dealer "enable" the cruise in the computer. Takes 15 minutes for the whole install.. And as discussed before technically you could use any universal cruise and do a pedal pull configuration, but it obviously isn't the best choice. SCS or Rostra makes the "kit" for this vehicle that comes with the new wheel/clockspring and directions on the install. Can't remember if I've used the kit on a diesel or not, but would only take a minute to call and confirm. Good luck,
Mike
Posted By: mexi
Date Posted: May 09, 2005 at 4:00 PM
I contacted rostra and they offer nothing for this vehicle. scs offers nothing for ford diesels
-------------
mexicang
|