06 ram qc underseat enclosure

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=105776
Printed Date: May 09, 2025 at 12:03 PM

Topic: 06 ram qc underseat enclosure

Posted By: widebodycrxsi
Subject: 06 ram qc underseat enclosure
Date Posted: June 29, 2008 at 8:39 AM

2 12" Alpine Type-R's

Alpine MRD M1001

Alpine MRV-F340

Kickers Components 5.25" rear 6.5" front

Kenwood Deck

2AWG Power and Ground Wire

8Awg Sub wire

2.4Farad Capacitor

posted_image

Replies:

Posted By: i am an idiot
Date Posted: June 29, 2008 at 8:54 AM

Good looking box, looks like a lot of work. If you find that you need some more airspace out of the box, when we do those trucks, we raise the seat 3 inches with couplers and bolts. It may also help you by getting the seat away from the drivers a bit. These are not the ones we use, Do not order these. This is just a link to a similar item incase you do not know what I am talking about. There is an industrial bolt supplier in out town, that is where we get them.

https://www.strongtie.com/products/CFS/CNW.asp

Posted By: widebodycrxsi
Date Posted: June 29, 2008 at 6:06 PM

Thanks I actually have to raise the seat around 2 inches to clear the box. My cousin did a similiar design and raised his seat 1.5" with no problems.

Posted By: widebodycrxsi
Date Posted: June 29, 2008 at 6:08 PM

I was actually going to make some blocks drill them out and just use longer bolts?

Posted By: upscaler
Date Posted: July 02, 2008 at 8:52 PM

Nice looking box. I'm just getting started in glass and I am anxious to get enough experience to do one of these type boxes.

Tim

Print Page | Close Window