exterior fiberglass work
Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136799
Printed Date: May 02, 2025 at 12:45 AM
Topic: exterior fiberglass work
Posted By: first_timer
Subject: exterior fiberglass work
Date Posted: June 14, 2014 at 12:39 AM
I'm working on molding in new taillights on my tail panel that is made out of flexible TEO. I'm updating the taillights on my car so I purchased a new tail panel section that is also TEO. I want to cut out the old taillight section and mold in the new taillight section. What is the best way to do this without it shrinking up and leaving a faint line where I made my cuts? I know there has to be a way to mold everything in that will not cause this issue later on. I don't want this to come back over time.
What materials do I need to use? Thank you
Replies:
Posted By: digdug18
Date Posted: April 04, 2016 at 12:26 PM
TEO? Perhaps pictures would help, I can't figure out what exactly you're wanting to do.
|