raised vinyl logo

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=18731
Printed Date: August 13, 2025 at 12:28 PM

Topic: raised vinyl logo

Posted By: amigoboom
Subject: raised vinyl logo
Date Posted: September 09, 2003 at 10:51 PM

i have made a trunk lid cover and put a 1/8" logo on it. last time i atempted this i used a 1/2" logo and could not get the vynil to form around it. i think it will be easeir now w/ the thinner logo but does anyone have any tips on vyniling this?

Replies:

Posted By: lncmarkviii
Date Posted: September 10, 2003 at 1:35 PM

use good contact cement, on both surfaces. also try a little heat on the vinal, not so much that you melt the stuff, just enough to make it plyable

Print Page | Close Window