Print Page | Close Window

fg on plastic door panel

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=26286
Printed Date: May 10, 2025 at 6:29 PM


Topic: fg on plastic door panel

Posted By: beyondamfm
Subject: fg on plastic door panel
Date Posted: February 11, 2004 at 12:24 PM

I was wondering what kind of tricks you guysare using to make fiberglass/resin stick on plastics. just curious. thanks

-------------
The Clear Bra Guy
KCs premiere paint protection guru



Replies:

Posted By: Velocity Motors
Date Posted: February 11, 2004 at 2:13 PM
Rough up the surface of the plastic and drill holes ( small holes ) so that the resin runs into these holes . This will allow the project to grab into the mold of the door better. Another way to do it is to have tabs or panel connectors fiberglassed into the project and then drill out the hole where they will fit into the plastic.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA


Print Page | Close Window