FG Starter

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=27654
Printed Date: October 31, 2024 at 7:11 PM

Topic: FG Starter

Posted By: sevenup_smile
Subject: FG Starter
Date Posted: March 03, 2004 at 11:41 AM

hey,

I have 00 Dodge Ram and thinking about adding a monitor were the passenger air bag exists(accident, never replaced). The air bag is not there anymore, only the shape of the air bag mold exists with the two vents on the side of it. How do i start fiberglass the mold. do i fiberglass while the it still in the truck or should i remove the piece and fiberglass. do i lay foil on the surface so that fiberglass doesn't stick. Any suggestions?

thanks,

7up

-------------
Be nice!

Replies:

Posted By: sam1
Date Posted: March 03, 2004 at 12:41 PM

im still pretty new to fg, but i think i would try to make a frame of the opening first. then you could stretch fleece accross it and theres youre mold for the front. not too sure, tho. maybe someone with a little more experience could help a little better than i can. but that sounds like a fun project. good luck.

btw, id take the piece out of the truck. its alot easier to work out side than in a confined space. also, mask EVERYTHING. when i was molding the fiberglass to my trunk, i accidentally dripped some resin on my bumper. i was so pissed, but i managed to catch it and wipe it up while it was still wet so you cant tell.

Posted By: sam1
Date Posted: March 03, 2004 at 12:52 PM

also, i dont know how much you know about fiberglass, but this is a great tutorial

https://www.e-kittan.com/fibre.html