Question About Pulling Mold

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=31988
Printed Date: July 07, 2025 at 11:07 PM

Topic: Question About Pulling Mold

Posted By: Spaceman Spiff
Subject: Question About Pulling Mold
Date Posted: May 11, 2004 at 2:42 PM

Well actually I already pulled the mold and did so prior to it being completely dry. That didn't turn out too bad but the mold is L shaped and kinda leans forward some. I figure the obvious way to fix this is to put some braces in to support the floor against the slightly leaning wall but wonder if there may be any structure issues by doing this. Should I finish this or scrap it and start a new one? Naturally I'd prefer not to scrap.

Replies:

Posted By: pureRF
Date Posted: May 11, 2004 at 5:56 PM

i would start over.

-------------
dream it, build it, fiberglass it

Posted By: audiomechanic
Date Posted: May 12, 2004 at 7:25 AM

i would start over as well........you could always throw a couple of braces in there to strengthen it and keep it standing straight

-------------

Print Page | Close Window