I am looking to have my Ipod Docking station slide in and out of a the compartment undernath my radio. I was wondering if anyone had done anything like this before and had any suggestions. I thought about using a linear actuator but I thought something that could move 75 lbs 4 inches in under a secong might be a little too much for moving something that probably isnt a pound. The other thought I had was doing a spring loaded thig like some cars use for their cupholders where you push in and it pops out, but I would rather have something motorized with a flip of a switch. With all the hype of MP# players I figured one of you must have done something like this before so I hope someone can help me. Thank you in advance for any help you can give me. Thanks again.
maybe try a power ant. I've used them for all sorts of neat stuff.
-------------
Nik
Jeeputer Progress
[|||||||||||-] 90%
Check it out.
Do you need it to be motorized?
I did one in my cointry but it is not motorized...
What type of car?
~Alvin
-------------
PG Limited Edition Octane Aplifier
PG Ti400.2
(2) JL12w6v2
Focal 165KF
JL TR-690TXi
Sony XAV-7W
Sony 10 Disc MP3 Changer
X-box
APC 350W inverter
Monster 1/0
Irragi 180A Alternator
Wow that is one messed up picture.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
oonikfraleyoo wrote:
maybe try a power ant. I've used them for all sorts of neat stuff.
wow I like that Idea .... i might have to try that!
Thanks I may try using a power antenna. That should work hopefully. Otherwise I have to think of somethingelse. I like the tray you Alvin, but I would like it to be motorized if poosible. It's a 2000 Civic and I was going to have it pop out from the dash kit pocket beneath the radio. Like I said I think I will try the antenna (thanks Nik), but if anyone else gets any ideas please post as well. Thanks for all those who have responded so far.
Matt