started my first project today

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=58750
Printed Date: July 09, 2025 at 8:21 PM

Topic: started my first project today

Posted By: snyderman5
Subject: started my first project today
Date Posted: July 02, 2005 at 9:49 PM

well I finally went out and started on one of two seperate sub boxes for my 12" RE SX's. My first hurdle was having to tape so damn much (that part sucked). Second was getting the resin mixture right. I wasted a whole gallon. Now the mold is made and ready to be built up. Quick question does the inside have to be smooth. These are going to be sealed enclosures.

Replies:

Posted By: maglin
Date Posted: July 03, 2005 at 2:45 AM

no. it can be rough a bit on the inside. neatness counts. its the outside people will see. i might be wrong there, but i highly doubt it.

i mean, dont have globs of crap sticking out like tumors or anything, and you should be fine.

~~Vinn

Posted By: oonikfraleyoo
Date Posted: July 03, 2005 at 12:27 PM

Even with "tumors" you should be ok. That may say something about the rest of the box though. posted_image

No need to sand what you can't see.

-------------
Nik
Jeeputer Progress
[|||||||||||-] 90%
Check it out.

Posted By: maglin
Date Posted: July 03, 2005 at 2:03 PM

*laughs* right on.

~~Vinn

Print Page | Close Window