PVa mold release

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=62062
Printed Date: May 15, 2024 at 7:48 AM

Topic: PVa mold release

Posted By: jman7695
Subject: PVa mold release
Date Posted: August 25, 2005 at 6:57 PM

Just created a mold of the back side of the fact. box in 04' Navigator. I used poly vinyl alcohol as the release agent. the mold came out great, but before I set a woofer ring and lay fleece should worry about the old PVA on it. just want the new glass to stick.

Thanks

-------------
JDm
70% installation, 28% product, 2% luck, try to be the best everytime!

Replies:

Posted By: realitycheck
Date Posted: August 26, 2005 at 7:40 AM

I would just wipe down the area that the fleece is going to stick to with rubbing alcohol or something. Then hot glue that bad boy.

-------------
Learning the trade one fiberglass creation at a time!

Print Page | Close Window