Door panels

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=63453
Printed Date: May 12, 2025 at 9:33 AM

Topic: Door panels

Posted By: dicksonjt
Subject: Door panels
Date Posted: September 28, 2005 at 9:22 PM

I know there are a lot of topics on door panels but i need to get something straight. If i want to make my whole door panel fiberglass, can i make a mold of it and then put the mold right over top of the vinyl with liquid nails or something like that?

Replies:

Posted By: phatx96xaccord
Date Posted: October 01, 2005 at 11:09 PM

i dont think that will work to well

-------------
would u like your chicken original or extra crispy?

Posted By: jlord16
Date Posted: October 03, 2005 at 1:53 AM

you COULD do it, i wuld pull the door panel off and then make a mould of the inisde, then glass the outside of the mould. This shuld make a replica of the original door panel, and then just screw this on

-------------
Clarion DB36MP
Infinity Kappa Perfect 10"
Respone 800w Mono
ALPINE MRP-F250
*Custom fabrications*

Posted By: abovestock
Date Posted: October 04, 2005 at 3:39 AM

Make a mold and then custom make a system to remove the pannel if need be. Try to make something along the lines of the factory pannel.

-------------
Why do you ask if I ate paint chips when I was younger?

Print Page | Close Window