Print Page | Close Window

Putting a top on to Fiberglass mold

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=66755
Printed Date: May 13, 2025 at 6:27 AM


Topic: Putting a top on to Fiberglass mold

Posted By: 540ofalpha
Subject: Putting a top on to Fiberglass mold
Date Posted: November 21, 2005 at 3:17 PM

Hopefully I can explain this well enough to get the forums help.

I created a form out of fiberglass in the back of my truck in a storage compartment.  Right now it looks like and elongated bowl.  What I need to do now is one of two things:  Attach and MDF top to it and/or Create MDF rings and attach fleece to the top

How do I adhere either the MDF board or fleece to the existing fiberglass mold and how do I insure it is completely sealed?

Thanks




Replies:

Posted By: footbaldd
Date Posted: November 21, 2005 at 5:57 PM
I leveled and scribed the mdf sides as close as I could to the mold. Then I squared up the sides and screwed them together. Next I drilled marked how I wanted the sides to sit on the mold, drilled pilot holes through the mold and into the mdf. I then layed down a couple wet strips of fg where the sides would be, flipped it upside down and screwed the two together while the glass was still wet. After that I put 2-3 layers attaching the mold and mdf. When it was dry I flipped it on its side and poored resin to fill the remaining gap between the 2, and layed a couple layers of fg on the outside, doing one side at a time and letting it dry before moving on. Go to my thread on the integra if you want some pictures.



Posted By: 540ofalpha
Date Posted: November 21, 2005 at 8:30 PM
thanks


Print Page | Close Window