kick panel fabrication

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=75857
Printed Date: May 07, 2025 at 5:54 AM

Topic: kick panel fabrication

Posted By: mep7851
Subject: kick panel fabrication
Date Posted: April 07, 2006 at 6:30 PM

I'm planning out how to install kick panels in my 1967 beetle for 5 1/4 polk component speakers. I am wondering how the kick panel should be attached to the side of the car body. Are they usually screwed into the sheet metal? Also, if anyone has pictures of a similar instal in a beetle, it would be hugely helpful.
Thanks

Replies:

Posted By: crazyoldcougar
Date Posted: April 07, 2006 at 7:44 PM

is there factory panels there or no?

if so make a mold of the factory panel and use the factory mounting points...with mine i put a screw right through the back side into the sheet metal usually.then install the speaker, hiding the screw...use self taper and silicone if you are concerned about the tiny bit of air loss that may occur from the screw hole.

-------------
Fiberglass Guru.

Posted By: mep7851
Date Posted: April 07, 2006 at 8:21 PM

no factory panels. Just metal

Print Page | Close Window