Sharp corners for glassing?

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=85319
Printed Date: May 09, 2025 at 9:19 AM

Topic: Sharp corners for glassing?

Posted By: dkeshish
Subject: Sharp corners for glassing?
Date Posted: November 07, 2006 at 11:59 PM

Hi guys I am in the process of making a cover for where my amps are out of fiberglass, the hole for viewing the amps are in question here, when fiberglassing do I try to get the corners as sharp as possible? how would i do this? should i just get it down and then fix the edges of the square hole (for the amp to show) with bondo? thanks all

Replies:

Posted By: maglin
Date Posted: November 08, 2006 at 12:05 AM

what angle?

i'm under the impression here that you use MDF to create corners and edges, rabit the MDF a bit to give the glass a pocket to sit in and bondo right over it.

Print Page | Close Window