step by step triple gauge pod

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=90348
Printed Date: April 25, 2024 at 8:25 PM

Topic: step by step triple gauge pod

Posted By: bbb1080
Subject: step by step triple gauge pod
Date Posted: February 11, 2007 at 5:34 PM

bracing and structure- 1/4 " mdf and pvc piping.

posted_image

wrapped in tiki lycra

posted_image

wrapped and fiberglassed( 2 layers of matte)

posted_image

trimmed with my kp air gauges

posted_image

with polycrete

posted_image

after it was misted with high build and filled accordingly

posted_image

high build

posted_image

done in paint

posted_image

Replies:

Posted By: ricoshay
Date Posted: February 12, 2007 at 9:55 AM

NICE! WHAT BRAND AEROSOL PRIMER DID YOU USE?

Posted By: bbb1080
Date Posted: February 12, 2007 at 1:01 PM

proform 1K highbuild. I usually spray it outta my 1.7 gun and use the catalysed 2K, but not for such a little piece. Careful if or when you buy to get the beige as the green or red sand really bad and tend to clump up the sandpaper

Posted By: maliboom
Date Posted: February 13, 2007 at 6:14 PM

Thanks for the step by step this is a project I was going to do in the summer. Good work and keep it up, by the way what kind of car is it going into.

Posted By: bbb1080
Date Posted: February 13, 2007 at 7:38 PM

bagged chevy half tonne with a full fiberglass interior. thanks for the feedback.

Posted By: hub_n_hun
Date Posted: February 13, 2007 at 8:19 PM

Wow, I have never thought of using pvc piping for that. You just saved me from cutting little circles of mdf with my router which is a pain in the arse. Also, the project is looking great, keep up the good work!

Posted By: bbb1080
Date Posted: February 13, 2007 at 9:18 PM

i use pvc pipe for everything, stuff is great!!

Print Page | Close Window