bonding fg pieces together

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=95345
Printed Date: May 11, 2025 at 7:13 PM

Topic: bonding fg pieces together

Posted By: kenzo42
Subject: bonding fg pieces together
Date Posted: July 05, 2007 at 2:07 AM

If I need to combine 2 pieces of FB together, what is the strongest material to use? Cement? Or just wrap the 2 pieces together in mat and place resin on them? Thanks.

Replies:

Posted By: subsonic6611
Date Posted: July 05, 2007 at 1:24 PM

use flash glue and then fiberglass over to make one piece

-------------
scott at subsonic6611@yahoo.com dealer for DD,AMPLE,ARK AUDIO,DB DRIVE.

Posted By: kenzo42
Date Posted: July 05, 2007 at 3:08 PM

subsonic6611 wrote:

use flash glue and then fiberglass over to make one piece

Is flash glue super glue???

Posted By: bellsracer
Date Posted: July 06, 2007 at 12:13 AM

I would just FG the pieces together. Rough the edges to be bonded together and about 2" up the sides with 60 grit sandpaper, mat the pieces and resin from both sides. (if possible) Then sand that back down and finish the project.

Ganbatte ne!

-------------
Never send your ducks to eagle school.
The difference between ordinary and extraordinary is that little extra.
The 3Ls of life: Learn from the Past, Live for the Present, Look to the Future.

Print Page | Close Window