Print Page | Close Window

fiberglass and plastic

Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=97212
Printed Date: May 09, 2025 at 9:28 AM


Topic: fiberglass and plastic

Posted By: pokoj
Subject: fiberglass and plastic
Date Posted: September 17, 2007 at 8:25 PM

How does fiberglass epoxy react with plastic? I am rebuilding a door panel, and there is a plastic pocket piece on the front part of the panel that hooks through the fiberboard and into the metal part of the door panel behind it. I need to keep this plastic piece on the panel. This is the only way to affix it back onto the door when I'm done. However, can I fiberglass over this piece in any way? Could I just stretch some fiberglass mat over it? The location of the 6 1/2" speaker is above this plastic pocket, and it should be part of the enclosure for the woofer if it is possible.

-------------
I wish I was cool enough for a cool signature



Replies:

Posted By: tubbs04
Date Posted: September 18, 2007 at 8:27 AM

I would use some epoxy and good ol body filler...



-------------
...don't crush the weasel...



Posted By: pokoj
Date Posted: September 19, 2007 at 7:56 PM
you mean inside the actual pocket or over the top of it, or both?

-------------
I wish I was cool enough for a cool signature


Print Page | Close Window