Print Page | Close Window

parrot ck3100 and 99 mazda protege

Printed From: the12volt.com
Forum Name: Cellular and Communications
Forum Discription: Cell Phones, Hands Free Kits, Bluetooth, Two Way Radios, CBs, Pagers, Wireless Internet, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=119594
Printed Date: May 02, 2025 at 10:11 PM


Topic: parrot ck3100 and 99 mazda protege

Posted By: canuk
Subject: parrot ck3100 and 99 mazda protege
Date Posted: January 24, 2010 at 3:52 PM

I connected the CK3100 with a recommended wiring harness. When the harness ground is hooked up the CK3100 works fine but the factory radio doesn't. Disconnect the harness ground and the radio works fine and the CK3100 doesn't work. What's going on?



Replies:

Posted By: dman007
Date Posted: January 25, 2010 at 7:22 PM
Not sure, but why not just cut the wire, so that radio works.  Then ground the end going into the parrot, so it works also.

-------------
DTS Performance
St Petersburg, FL



Posted By: canuk
Date Posted: January 25, 2010 at 7:41 PM
The wire you refer to cutting, is that the ground from the factory installed radio? The ground that's creating the problem is from the wiring harness between the radio and the parrot. It has to be hooked up to make the parrot work but it crashes the radio when it is hooked up.


Print Page | Close Window