Hey, I'm new to this forum as well to neon lights. I just bought neon lights form 12volt. And i had an installer but he bailed on me. I needed to know how to install it, and where would be the best way to put each wire, box, kit, distrubition block. and etc.. The care that i will be installing it into is an acura legend 94. 4 door. Yeah kinda weird, but yeah. :oops:I'm new to this subject. Please help me out. Anything you know might be very useful to me even though its not the biggest advice.
Thanks
yeah, i gottta a question about neon lights.
i installed 4 neon lights under my car. the distribution block isn't working.
so i put all (-) to connection then all (+) to another. It worked for a week. Then the on october 31 which was halloween, it stopped. That very same day it rained. But it worked for a while.then later it stopped. I"m not sure if its cuz of the rain. or is it becuz i switched it up and down to many times. or its just gay.
Then i checked out the fuse bulb thing. it was broken. i replaced it with another 1 . the exact 1. then i switched it on.. it on for a second then went off. i checked the fuse bulb thing again. and it was burnt.... so i put another fuse bulb thing and switched it on again. it went on again for about a sec then went off. i checked the fused again for the 2nd time and it was broken again... i did this about 3 times....
Now i'm not sure wut the hell is going on. The wires that are connected.. i checked and the (-) nor the (+) are not touching each other. SO i dunno.......
please reply here. or please email me at phan_nam420@yahoo.com
-------------
Can you explain where you are getting the power from, how you have it wired, switched, and fused?