I have a suzuki ozark 250 and i have 2 55 watt lights that i want to add to it. I know how i could wire it straight from the battery or the fuse block, but i want it to turn on preferrably with the high beams. So I can switch between lows and high + 55w lights. Does the light power run straight through the key switch and the high/low switch or is there a relay? I don't know what the 3 or 4 modules are for in the back, maybe relays or resistors or something, i don't know.
I unplugged the left light connector and stuck the 55w light negative on the ground pin then i put the positive on one of the positives, i don't know which though but the other light got brighter when i did that (the 55w did not turn on). then i took it off and did it again and maybe they contacted or somethign, maybe not, but blew a 20 amp fuse
would i have to put a bigger fuse in or something with the addition of the lights or should it be alright?
does anyone know where i could get a wiring diagram for my quad? 2003 suzuki ozark 250
thanks a bunch
James
Use a relay.
Use a relay that is triggered with the high beams. Tap the relay onto the high beam wire and to the lights.
85: Ground
86: High Beam wire + (just need to tap into one side)
30: 55 watt lights +
87: Battery
PM us if you have any more questions
-------------
Never send your ducks to eagle school.
The difference between ordinary and extraordinary is that little extra.
The 3Ls of life: Learn from the Past, Live for the Present, Look to the Future.
if you havn't tried of this i was wondering, with my experience with quads they dont use a chassis ground for the lights, they have them wired with neg wire straight to batt neg. just wondering but if yours is done that way tell me, cuz i havnt seen one like that before
-------------
