wiring 2 dvc 12’s to a 4 ohm load
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=100169
Printed Date: May 11, 2025 at 5:53 PM
Topic: wiring 2 dvc 12’s to a 4 ohm load
Posted By: rene123
Subject: wiring 2 dvc 12’s to a 4 ohm load
Date Posted: December 18, 2007 at 10:06 AM
I have an amp that bridges to 4 ohms. I want to maximize my amp power so I bought 2 DVC 12's. I have a few diagrams from this site and from crutchfield that show the wiring diagram clearly. I know that i am supposed to run a wire between the neg/pos on one of the voice coils for each sub. My question deals with the wires heading to the amp. The diagram tells me to connect the positives together and the negs together and run it to the amp. My question is do I combine the 2 pos and then just send one wire to the pos or do I run both pos wires all the way to the amp (ofcourse doing the same on the neg side)?. Any advice would be appreciated.
Replies:
Posted By: jl.w7
Date Posted: December 18, 2007 at 10:48 AM
is you amp only capable of going down to 4 ohms? are the subs dual 4 ohm vc's? if so then i think your plan kinda backfired.
-------------
MECP Certified
(2)Infinity 3.5" 3012CF
(2)Infinity 6x9 9612I
(1)Sony CDXGT710
(2)MTX TC510 and,
A load of dynamat!
1982 Chevy Cavalier
Posted By: DYohn
Date Posted: December 18, 2007 at 11:46 AM
|