99 jeep cherokee running 0ga cable

I have a 99 Jeep XJ Cherokee and wanted to know if any of you guys have run 0ga in it before. On my previous vehicle (Suburban) I ran the cable to the rear under the body along the chassis and back up again.

In the jeep, I don't see were I could run the cable through the interior but maybe you guys have some ideas.

Hope you could give me some tips..

Thanks...

Here's my tip:  never run a power wire under the vehicle.  Find a way to run it inside.

-------------
Build the box so that it performs well in the worst case scenario and, in return, it will reward you at all times.

Thanks, will take apart the interior and see if there is space on either side. Will let you guys know..

Yeah, that sounds like a good way to ruin some expensive cable, if something were to bounce up and slice it, then you have a risk of starting a fire or something unless you were to pull over and unhook the cable from the battery... which would be a pain in the neck. (Not as bad as replacing that cable probably though)

-------------
Soldier: This is the worst part. The calm before the battle.
Fry: And then the battle is not so bad?
Soldier: Oh, right. I forgot about the battle.

Any luck on running the 0 ga?

No luck yet, for the past couple of weekends...every time I get everything together, it starts to rain. Will let you know when I get it done.

Was thinking for running flexible conduit underneath but still scoping it out..