Print Page | Close Window

6 channel amp, 4 ohm dvc sub

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=103832
Printed Date: May 13, 2025 at 12:08 PM


Topic: 6 channel amp, 4 ohm dvc sub

Posted By: waveshredder
Subject: 6 channel amp, 4 ohm dvc sub
Date Posted: April 08, 2008 at 3:04 PM

Hello all  again! I know there has been many posts about this, but I'm just a little confused (sorry). I have a Pyle PLAD-618 amp, 6 channels. I have the 4 speakers in the car hooked up to the first 4 channels (normal setup). I have a Pioneer TS-W307D4 subwoofer, DVC, 4 ohm. How should I hook up the sub with the remaining 2 channels? Bridge channels 5 & 6 and wire it up in series? or Hook up channel 5 to one voice coil and channel 6 to the other one? The amp is 2 ohm stereo stable. I'm trying (obviously) to get the most out of what equipment I have. I REALLY appreciate your advice and help. Thank You in advance.

-------------
"To defy the laws of tradition, is a crusade only of the brave" Primus



Replies:

Posted By: Blowntweeters
Date Posted: April 08, 2008 at 3:34 PM

you are going to get 4 ohms stereo or 8 ohms bridged. the amp with see it the same .giving. the same power both ways. i would get a cheap mono block amp.if it sounds like crap. try it see how it sounds.



-------------
1974 ford pinto 4 15" punch Z power punch bd 1001 pioneer DEH-6700


Print Page | Close Window