Print Page | Close Window

alpine amp crossover

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=104704
Printed Date: May 15, 2024 at 4:17 AM


Topic: alpine amp crossover

Posted By: fplcman
Subject: alpine amp crossover
Date Posted: May 13, 2008 at 6:35 PM

I purchased the Alpine MRP-F250 amp and need help with the setup.

In front I have the Alpine SPR-17S which are the 6 ½ Component 2-way with crossover included.

https://www.alpine-usa.com/US-en/products/product.php?model=SPR-17S
 
I have the SPS-17C2 in the rear doors. They have a Frequency Response: 35Hz - 30kHz
 https://www.alpine-usa.com/US-en/products/product.php?model=SPS-17C2

How should I set up the Amp?
In the front I have the amp’s crossover mode set to OFF
In the Rear I have the amp’s crossover mode set to HP and the crossover knob set to 80HZ.
I am using the GM factory Navigation head unit.
Does this sound correct? I will be adding Alpine 12” sub later this month.

Thanks for you help




Replies:

Posted By: jmelton86
Date Posted: May 13, 2008 at 7:47 PM

You actually should set the front crossover to HP as well. Set to about 80Hz. Other than having the gains set correctly, you're good to go.

You will be adding a dedicated sub amp with the sub, right?



-------------
2013 Kia Rio -90a alternator
DDX470HD GTO14001 GTO1014D (x3)
Big3 in 1/0G
1/0G to GTO14001




Posted By: fplcman
Date Posted: May 14, 2008 at 12:38 AM

Yes I plan on :

2 - Alpine SWR-1222D DVC 2 ohm I will wire them series/parallel to have a 2 ohm load.

I am looking at the Alpine MRP-M1000 amp or MRP-M850 amp. I am still up in the air. I think this will round out my system.






Print Page | Close Window