hooking up two 2 ohm dvc woofers

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=105154
Printed Date: May 02, 2024 at 10:17 AM

Topic: hooking up two 2 ohm dvc woofers

Posted By: jimgustafson34
Subject: hooking up two 2 ohm dvc woofers
Date Posted: May 31, 2008 at 2:21 PM

Im just wondering if there is any way to hook up 2 lanzar optidrive 900 watt rms 12" subwoofers to a BOSS AUDIO

Model: DD3600

DIABLO CLASS D MONOBLOCK POWER AMPLIFIER (3600W X 1 MAX @ 1_, 1850W X 1 RMS @ 2_, DIM: 2.31"H X 11"W X 14.19"H)

SIGNAL-TO-NOISE RATIO: > 100 DB;3600W X 1 MAX @ 1_;1850W X 1 RMS @ 2_;FREQ RESP: 20 - 15000 HZ; so that i can get a one ohm load or do i have to do it 2 ohm load?

-------------
KEEPIN IT REAL!!

Replies:

Posted By: the12volt
Date Posted: May 31, 2008 at 2:27 PM

Using all coils on two 2 ohm DVC woofers, you can get .5, 2, or 8. https://www.the12volt.com/caraudio/woofer_configurations.asp?Q=2&I=22

-------------
posted_image

the12volt • Support the12volt.com

Posted By: joch1314
Date Posted: May 31, 2008 at 2:33 PM

you can't get it to 1 ohm using all four voice coils....but you can get it to one ohm with just using one voice coil on each woofer! of course doing that would diminish the power! i would recommend that you just wire it for 2 ohms! i don't really think that amp will be too stable on a one ohm load....no offense but in electronics, just like everything else, you get what you pay for!!

-------------
...half of the truth can be worse than a lie. <----Roger Russell said that..

Print Page | Close Window