Print Page | Close Window

remote turn on lead

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=106055
Printed Date: May 03, 2024 at 10:41 PM


Topic: remote turn on lead

Posted By: travis 06
Subject: remote turn on lead
Date Posted: July 11, 2008 at 7:08 AM

Installed system in 08 Accord. Which wire should I connect my turn on lead to, so that the amp comes on with the factory radio. Had it connected to the violet colored wire near fuse box and the amp came on in the second key  position but not the first like it should. The way it was connected there was this annoying boominess.




Replies:

Posted By: Big Dog
Date Posted: July 11, 2008 at 1:17 PM

I don't think there is one.

The boominess is because the amp turned on before the radio.

You can try the YELLOW /GREEN that runs from the radio to the rear glass antenna box but I'm not sure if it stays active when you put a CD in the player.

Second option is an switching module like from DEI the 55000 or from PAC the TR7. These use a rear speaker signal to create a turn-on signal.



-------------
Prepare your future. It wasn't the lack of stones that killed the stone age.



Posted By: fiberglasslvr
Date Posted: July 12, 2008 at 1:23 PM
you could try tapping the red wire in the ignition harness , that is the accessory


Print Page | Close Window