I have a 300 amp Iraggi alternator to install on my 93 civic si. however I do not currently have my subwoofers and amps hooked up. I was planning on waiting to install the amp for after all that equipment was installed since I am going to be relocating the batteries to the trunk. However since I cannot get all that done for a while id like to get the bracket made for the alternator and have it installed to the front battery for now...is it ok to use 4 guage wiring / stock wiring for that alternator for the moment since I wont be pulling much more than stock amperage?
I dont want to cut the 0 guage wiring incase I end up needing the full run to get to the rear mounted batteries later on. But it would help me later on if the alternator was already installed and if I only needed to replace the ground and power wires on it to 0 guage.
pretty much is it safe to install a 300 amp alternator with 4 guage wiring if im not pulling much more than stock amperage at the moment?
ii would run 0 guage to the alternator anyways since you might end up doing it anyways witht e big three and all.
-------------
1993 sdv
Alpine 4x6 6x9 5 1/4 swr-10d4
alpine v60
12.5 VGA flip down
Nettop pc w/10" touch screen
78nova
5-re audio 5x7 ,10" sub &
Xtx-500.5
"Take the faceplate off get the jumperpack"