Has anyone installed Infinity Perfect 6.1 - 61/2" component speakers in the front doors of a 2003 or later 350z? I want to make sure that the the door is deep enough to accomodate the speaker and crossover placement.
-------------
"Rudebwoy"
i would not recomend placing crossovers inside the door, always try to place them behind the vapor barrier or even better inside the car. that i can rember there is no depth problems with that car. might have to fabricate/buy a speaker mount tho.
-------------
life is a comedy to think, a tragedy to feel
The factory speakers do have a spacer with them, and come off with the speaker. You might want to get a 1/2 inch spacer just to accomodate the depth of the aftermarket speaker. It won't hit the window but it does hit the window track, and won't allow the speaker to fit right. You won't have that problem with a spacer.
-------------
...half of the truth can be worse than a lie. <----Roger Russell said that..
Thanks for the help.
-------------
"Rudebwoy"
The reason I wanted to mount the crossovers behind the door panel is because I will only have to run one set of 16ga wire through the molex. I guess if I can drill the molex to accomodate two runs of wire, then I can put the crossovers behind the kick panel or next to the amp.
-------------
"Rudebwoy"
duncan911 wrote:
The reason I wanted to mount the crossovers behind the door panel is because I will only have to run one set of 16ga wire through the molex. I guess if I can drill the molex to accomodate two runs of wire, then I can put the crossovers behind the kick panel or next to the amp.
it's ok to put the cross over in the door, just make sure it's on the inside of the door not behind the speaker. either way was just some advice good luck with your project.
-------------
life is a comedy to think, a tragedy to feel