clarion vs755 remote turn on issue

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=106528
Printed Date: May 12, 2025 at 5:22 AM

Topic: clarion vs755 remote turn on issue

Posted By: overworked
Subject: clarion vs755 remote turn on issue
Date Posted: August 02, 2008 at 1:34 PM

So I've installed a VS755 and I'm using the remote turn on lead to energise the coil of a relay. The issue is, the moment it does this it cuts the sounds from the RCA outputs. Remove the load from remote wire and a few seconds later, audio returns. What thoughts do people have? Could the relay have too low of a resistance possibly and possibily causing a short and the unit is going into protect mode? as a side note, it doesn't stop the video..just the audio.

Replies:

Posted By: Big Dog
Date Posted: August 05, 2008 at 10:38 AM

I have a VRX575USB but haven't tried what you said but you might have to use a driver like so:

posted_image

-------------
Prepare your future. It wasn't the lack of stones that killed the stone age.

Posted By: overworked
Date Posted: August 05, 2008 at 3:12 PM

Actually, I tried pretty much the same thing and no luck. Swapped out the unit with the last one from the soundboard and lo and behold it was a unit issue....I just always blame the unit last.

Print Page | Close Window