sir pnr2 receiver

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=108551
Printed Date: May 13, 2025 at 12:32 PM

Topic: sir pnr2 receiver

Posted By: daburrrninator
Subject: sir pnr2 receiver
Date Posted: October 30, 2008 at 11:10 PM

I just got a SIR-PNR2 that I'll be installing, just not certain if this is a good way to power it or not. The instructions say to wire it to 12v, I'm assuming a switched 12v source, am I right? I was thinking of wiring it directly to the 12v power source of the HU. The connector it comes with is already factory fused with a 1A fuse. Would this be a good or bad idea? I really dont want to go straight to the battery and I dont want to cut any factory wires.

Replies:

Posted By: megaman
Date Posted: October 31, 2008 at 8:32 AM

You will need a 12 volt constant. Yellow at your new HU harness.

Posted By: daburrrninator
Date Posted: October 31, 2008 at 10:06 AM

Thats good, I was hoping I'd be able to splice into the harness, it will make things so much easier.

Print Page | Close Window