mtx thunder8 1000d 2 channel

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=110938
Printed Date: May 16, 2024 at 12:33 AM

Topic: mtx thunder8 1000d 2 channel

Posted By: hookedonaudio
Subject: mtx thunder8 1000d 2 channel
Date Posted: January 24, 2009 at 2:35 AM

I have a mtx thunder8 1000d 2 channel and 1 kicker L7 dvc square sub, is there any way to bridge this amp to 1 sub because there is no diagram or info on bridging this amp in the manual( would it be safe to run 1 channel to each voice coil.

Replies:

Posted By: i am an idiot
Date Posted: January 24, 2009 at 4:48 AM

That is a 1 channel amplifier. It is stable down to 2 ohms. If your speaker is a dual 4 ohm driver, then you can connect one voice coil to each set of terminals. If it is a dual 2 ohm driver you will need to wire the voice coils in series.

Print Page | Close Window