Print Page | Close Window

1/0 ga won’t fit

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=112311
Printed Date: May 14, 2025 at 1:26 PM


Topic: 1/0 ga won’t fit

Posted By: elemen0hpey
Subject: 1/0 ga won’t fit
Date Posted: March 12, 2009 at 8:01 PM

Guys,

I bought a Kicker 1/0ga dual amp install kit and the ANL fuse holder seems like its too small to fit the 1/0 into the ends. I've heard of 4ga 1/0ga combo fuse holders but never used one before.. Should I strip off some of the outside wires on the 1/0 to make it fit? What am I doing wrong? I've already stripped the rubber insulation off and it still doesn' fit. Any ideas?

-------------
hello



Replies:

Posted By: i am an idiot
Date Posted: March 12, 2009 at 8:49 PM

Some of those fuse holders have a ring inside of the connection that needs to be removed to insert the 0 Ga. wire.  

Can you post a link to the install kit so I can see the fuse holder?




Posted By: j.reed
Date Posted: March 12, 2009 at 10:24 PM

+1 Also if you are talking about it not fitting the amp get a D block from 0 to 4 gauge to run to the amps.



-------------
posted_image


Print Page | Close Window