amp goes in protect mode.
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=112402
Printed Date: May 13, 2025 at 3:21 PM
Topic: amp goes in protect mode.
Posted By: highhilltx
Subject: amp goes in protect mode.
Date Posted: March 16, 2009 at 12:34 AM
i have a hifonics 1500 brutus class d on 4 kicker cvrs 10s dual voice coil. the systems plays good, amp does not even get warm, if i play my music, cut my car off, and turn it back on the amps goes to protect mode. whenever the amp starts playing again, it plays the music fine, never cuts off in the act of music playing, but if i turn da car off, and turn it back on the amps goes to protect. pls help.
Replies:
Posted By: i am an idiot
Date Posted: March 16, 2009 at 6:51 AM
Where did you get power for the remote terminal of the amp? Factory deck, aftermarket deck??
Posted By: highhilltx
Date Posted: March 16, 2009 at 1:05 PM
i got a jvc El Kameleon KD-AVX44 A/V. i got the remote to the amp, on 'remote out' from the radio, i also have a audiocontrol epic 160 hooked up with the radio. i too have it on the remote out. i know it has to be something with the remote, because whenever the amp is in protect mode, my epicenter bass/power light blinks together, unless something is wrong with the epic, causing it tomess with the remote on the amp
Posted By: soundnsecurity
Date Posted: March 16, 2009 at 3:34 PM
move the amp remote wire to the red wire behind the radio and see what that does.
-------------
Posted By: highhilltx
Date Posted: March 16, 2009 at 9:53 PM
thank u, i also did that today, and its still doing the same, i think something is wrong with da amp/ and the epic is getting a signal through the rcas causing it to blink with the amp
|