hey guys i was just wondering if you could point me in the right direction for this. a friend of mine wants me to add a sub to her toyota matrix. what PAC product would i use to add a sub amp onto the factory radio? which PAC LOC? ive never done a LOC but do they install by the radio or by a speaker? she also wants a iPod integration. they dont seam to hard to do i just would like to get your guys opinions if im doing it the right way and all. thanks!
This one gives you a remote out to turn on the amplifier.
|
| | The Trunk-LOC is the same as the SNI-35 below but with a low voltage trigger built into it. The low voltage circuit senses voltages as low as 0.8 volts and gives you a 12 volt output with a one second delay. | • Trigger off of speaker leads or +5 volt remote wires.
• Remote turn on for aftermarket amplifiers in vehicles without a factory remote wire.
• Eliminates turn on pops in amplifiers. | | | |
|
This one does not provide the remote output.
|
| | SNI-15 converts 10 to 30 watts per channel speaker level output into a pre-amp signal. Perfect when adding an amplifier to a factory or aftermarket radio. Great for getting an additional set of pre-amps outputs from a head unit equipped with only one set. | • Fixed 10:1 conversion.
• Linear from 20-20,000Hz at +/- 5 dB, while maintaining signal phase.
• Isolates input and output circuits to prevent ground loop noise. | White: Left(+) speaker
WHITE/ Black: Left(-) speaker
Grey: Right(+) speaker
Grey/Black: Right(-) speaker | | |
|
how would you go about installing the Trunk-LOC? do you just wire it up to a speaker or how does that work? is that the only thing i can do for her car?
