how to hook up a 4 channel amp

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=114216
Printed Date: July 12, 2025 at 3:03 PM

Topic: how to hook up a 4 channel amp

Posted By: bigshooz1988
Subject: how to hook up a 4 channel amp
Date Posted: June 04, 2009 at 10:18 AM

Hey, i have a question that hopefully someone could help me out with. How would i go about installing a 4 channel amplifier to a stock radio.the car is a 2001 Pontiac Sunfire. I know that the speaker leads from the radio have to be disconnected and new wires have to be ran. But my question is do i need a line output converter and how would i install it? any help is greatly appreciated.thanks

Replies:

Posted By: i_want_the_boom
Date Posted: June 04, 2009 at 11:10 AM

connect your line out converter to your rear speaker leads and leave the factory wires connected to you radio. then run new wires from your amp to the speakers,

-------------
If the trunk dont rattle then its not loud.
If it's to loud then you're to old.

Posted By: memfus_boi
Date Posted: June 04, 2009 at 10:05 PM

IMO i think you should get an aftermarket unit before thinking about a 4 channel amp install

-------------
If I'm to loud, then you're too old!!!

Print Page | Close Window